Easy, quick fix, since it was just a little sensor. So, they replaced the entire steering column again. Warranty replaced with a newer part which should not fall off. Maybe I like learning how things work. Any advice on how to fix this myself? Had to replace the turn signal switch to fix the problem. All three black wires connect in one terminal. Pull out hear tail light fixtures, remove bulbs from recepticals and check for melting plastic, usually between the black wire hot wire and one or more colored wires.
It definetly worked before taking it to the dealership. In replacing the faulty socket assembly, the multi wire splice location moves to the outside of the socket as shown below. Obviously I've considered that option :D lol well if the dealership broke something on my car you can be damn sure I would take it back and demand that it gets fixed. In this case dark blue. Though it sounds very odd.
Had to pay to have car towed 100 miles. Gear shift indicator always shows R reverse. There will be one set of wires that connects the tail light assembly to the rest of the minivan--try not to damage that set of wires. Just undo the catches easier said than done, but still not too tough and it comes apart. The contact had reached out to the dealer on multiple occasions but the dealer failed to return any calls. The automatic headlights were on all the time and I could not make out the radio display in the sunlight as a result. Any advice on how to fix this myself? This time they had to reprogram car and key.
Replaced a part of the coolant lines and recharged the system. If so, cut out old Pig Tail, get a replacement Pig Tail, soder it in I think about 6 wires , and use electrical shrink wrap around sodered joint, install new bulbs using Di-electric grease in the socket. Car is unsafe and leaves me stranded regularly as it pours gas out of car. Very pleased with warranty coverage on this. I really hate dealing with car mechanics - it seems like everytime I take a vehicle to get something looked at or the oil changed - something else on the car breaks before I get back home. This updated powerplant will put out 155 hp at 6,100 rpm and 150 lb-ft of torque at 4,900 rpm.
Realigned the part and beefed it up a bit with some duct tape and its been working so far for about over a year. I was skeptical at first yes the doors locked but would not start the car. The vehicle was not repaired. Service rep unable to replicate problem. The video above shows you how to change a burnt out front turn signal bulb on your 2007 Pontiac G5. It under the light and in a position behind the bumper cover. It's really eerie to me, haha.
Gear shift lever knob had started to peel and feather, replaced knob. The contact stated that while driving downhill approximately 45 mph on a gravel road, the vehicle spun out of control and landed upside down. We are a community of Pontiac enthusiasts. Jack ------- The poster also mentioned something I forgot; use some kind of grease in the sockets any time you have reason to access them. Light came on 1 week later.
Then the fuel economy became inaccurate. Jan 2013 Front speakers cut off intermitently. Pontiac G5 in New Jersey, United States Mar 2011 - Aug 2013 Mar 201267742 km Trim plate around sunroof switch was loose Dec 201283871 km Emission Crankshaft Sensor Pontiac G5 in North Carolina, United States Apr 2010 - Jan 2013 Feb 201135484 km Replaced main fuse box and transmission module. The air bags did not deploy during the impact. This engine tends to fade after the initial surge. Once all these are removed, you will access the bulbs. The first step in removing the headlight assembly is to remove the push pin retainers for the upper portion of the bumper cover assembly.
The manufacturer was also contacted and could not provide an estimated date for when the contacts vehicle would receive the recall repairs. You'll need the hexagonal wrench to remove them, because a normal screwdriver won't do it. I've read various info on what causes the noise - is it the signal switch or a recording within the radio? Often, downshifting through a couple of gears is necessary with the five-speed manual transmission to get the I4 up and moving on the highway. I cleared it, but problem immediately came back. With them pointing down gravity is in our favor. The video above shows you how to change a burnt out front turn signal bulb on your 2007 Pontiac G5.
Ive been trouble shooting a problem with my car with no success. Continued with my drive, then it happened when I pulled into a shopping center to run some errands and same deal. In replacing the faulty socket assembly, the multi wire splice location moves to the outside of the socket as shown below. I've read various info on what causes the noise - is it the signal switch or a recording within the radio? Just undo the catches easier said than done, but still not too tough and it comes apart. When changing the turn signal bulb in your G5, be careful not to touch the glass portion of the bulb with your fingers as this will cause the bulb to burn out prematurely. The vehicle was taken to a repair shop and the mechanic replaced the passenger side headlight. The CarGurus View Basically a rebadged Chevy Cobalt, the 2009 Pontiac G5 offers little in the way of refinement, engine performance, or cabin storage.