Then you remove the 2 bolts that hold the starter to the bell housing. Make sure you unplug the battery before you try to remove it. A Ford Expedition starter gets your vehicle going and consists of important components like a safety switch, battery cables and an ignition switch. Is has a positive cable from starter solenoid. Remove the starter terminal cover. Clock positions of 1o'clock, 5o'clock, 9o'clock.
Failure to do so may result in unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations. However with the proper length extension and socket. Then you remove the 2 or 3 wires from the starter. Patience is required as are some very contorted positions sometimes along with the correct tools to gain access to the bolts. Torque to about 30 lbs. Big trips in your Expedition require a lot of planning and logistics, so the less mechanics you have to worry about, the better. Heres's the procedure on how to remove and install starter for your 03 Expedition.
First remove the battery cables from the battery. Generally, you first remove the neg. The bottom bolt is also the ground terminal, therefore you will need a deep socket for that bolt. Connect the solenoid S terminal connector, if equipped with a starter mounted solenoid. They are usually hard to get too. Raise and safely support the vehicle. Remove the starter motor from the vehicle.
Finally reconnect the neg battery cable and start your Expedition!! The top bolt is on the top of the starter and you could fit your hand up there to feel it and place the socket. Patience is required as are some very contorted positions sometimes along with the correct tools to gain access to the bolts. Disconnect the solenoid S terminal connector, if equipped with a starter mounted solenoid. They make sure you find the right product at the right price and are happy to tell you about our Loan-a-Tool Program, which allows you to handle auto work yourself. Mar 08, 2011 Thank you for using Fixya. The 3rd bolt is between the bottom and top bolts.
Remove the negative battery cable at the battery. They are usually hard to get too. Remove the electrical connections to the starter and label for replacement. Connect the battery ground cable. Every expedition begins with the turn of a key, and your Ford Expedition is no exception. Make sure protective caps are in place when maintenance is complete.
Connect the negative battery cable. The other two are on the bottom and can be visually seen. Excellent fit, secure performance, and robust framework are the major qualities of Bosch's original equipment starter. Oct 09, 2009 You will need some tools that will give you enough reach to go over the top of the starter, and more than likely a swivel joint to get enough access to remove the bolts. Pull straight off to prevent damage to the connector and S terminal. To disconnect the hard-shell connector from the solenoid S terminal, grasp the plastic shell and pull off; do not pull on the wire. Tighten the terminal nuts to 79 inch lbs.
Decreased level of driving quality and general functionality, higher petrol consumption, or threat of component malfunction are merely several negative aspects of driving a car with a defective auto component. . Lube the bolts must be clean too - place the new starter. There are 3 bolts - 13mm. This replacement product is properly designed to perform like the primary starter that came installed with your car or truck. Upgrade your stock or worn out starter for easier starting with a new.
Remove the starter motor retaining bolts. Disconnect the negative battery cable. Raise and support the vehicle; refer to. Connect the negative battery cable at the battery. Tighten the bolts to 15-20 ft. Hand tighten mounting bolts 5. Make sure protective caps are in place when maintenance is complete.